Neverside

Need some advice on my wee little project

I'm modeling this Awing to learn about modeling. Basically I could use your opinions on what I could do to improve it. Any tips or advice let me know. I'd like to have your thoughts.

Strike

I dont have any reference to compare to but assuming the model is accurate i would dirty up the image maps a bit. They look rather clean at the moment. Could do with dirt and noise on them. Shoing things like battle damage and stress - unless its fresh of the prodcution facility

Also the weld lines and rivets look a little big if they are a bump map you may want to reduce the power a little. If you compare the size of the line to the size of the cockpit then the lines look like they would be a couple of inches wide

But very good so far - keep up the good work

___________________

Why do we have to learn English? I speaks da *****

Thx!

I will work on those suggestions, I have already started work on several new additions. I'll post my progress as I go along.

Again I appreciate the response. Sometimes staring at this thing for too long makes it all fuzz together and I can't seem to see what should happen next to improve it.

yeah u may find it easier to walk away for a few days and do something different - even do no 3D/graphics work. Then when u come back your brain has had a rest and is ready to look at it again.

___________________

Why do we have to learn English? I speaks da *****

Ok here's another

Well this is what I have done. Made textures dirty, and ahh tweaked ...... forever.

Strike